![]() Use the parameters digital_port_name to define the port you want to use. Reads a single bit of the specified I/O port. Valid range for your hardware are listed in the Universal Library User’s Guide.Ĥ.2.5. The table below shows the range codes for the input_range_code and output_range_code parameters and the voltage range, which can be detected. Coises are CELSIUS, FAHRENHEIT, KELVIN, VOLTS and NOSCALE. Last analog input channel (See pin description of your device). The following parameters are mandatory or optional for initializing an instance of this plugin: Refer to for the names, titles, and contact information of each key executive at Measurement Computing. Digital I/O, counter and temperature ports can be used by the exec-functions, see in the description below. The analog output values are set by the setVal-function. Returned data are a dataobject of the size m x n, where m are the number of channels and n the number of acquired samples. The analog input channels are acquire by using the acquire-function, then the data are returned to python by the getVal- or copyVal-function. This board number is a mandatory itom plugin initiation parameter. Before you can use this itom-Plugin, you must configure the D/A board using the software ‘InstaCal’.įirst define a board number in the software ‘InstaCal’ (e.g. Measurement Computing devices are available with analog input and output, digital I/O, counter and temperature ports. ![]() The MeasurementComputing is a itom-Plugin to give a direct access to the MeasurementComputing USB digital to analog converter (e. MeasurementComputing Digital-Analog Converter Plugin.
0 Comments
Leave a Reply. |